Page 1 of 1
Please help - back panel!
Posted:
Thu May 27, 2004 5:35 pmby moonshadow
Posted:
Thu May 27, 2004 8:42 pmby Geekgirl
Are you talking about where the ports and connectors show through the back? Or are you talking where the pci slots are located near the bottom?
You should of got a plate that came with the board you just pop out the one (if any) on the case and click the one designed for the board in place. If you are talking about were you would put adapters your case should of came with those and when you install an adpater you pop it out to expose the port. If Im not even in the ballpark give me more details.
Posted:
Thu May 27, 2004 9:22 pmby liljim
That board is an ATX Form Factor and should fit in any ATX case.The I/O backplate that i "think" your reffering too should have came with the board.As Geekgirl suggest,you should be able to remove (if any) whats there and place your plate in.If your board didnt come with one you will probably have to contact whoever you purchased the board from,i've been searching for just a plate and havent found any.
Posted:
Thu May 27, 2004 9:34 pmby moonshadow
hi thanks for the replies. I'm talking about where the ports and connectors show. The back panel didn't come with the board and I guess this is because it was one of ebuyer.com's blowout deals.
The board did fit the case, it's just there's a big space around all the ports and connectors.
Any ideas/suggestions?
Sticky tape?
Posted:
Thu May 27, 2004 9:50 pmby Geekgirl
The problem with open spaces is the air flow. Cases are designed to have the back panel closed to have the correct air flow provided by the fans. Open spaces are perfect for dust bunnies which then become heat problems.
:b2: :b2:
Posted:
Fri May 28, 2004 8:05 amby liljim
My only though would be to contact asus with your board info and see if you can get one straight from them.
Posted:
Fri May 28, 2004 9:07 amby noby
or you could go to a store where they repair the comp's and ask for a backpanel, they often do have 'em.
noby
Posted:
Sat May 29, 2004 12:48 amby moonshadow
wow, these forums really are great.
thanks for your help guys, I'll try those suggestions on monday and post the outcome in case anyone else experiences the same problem.
cheers
Posted:
Sun May 30, 2004 11:46 amby icecube
there is one thing that you will have to realize. To install that plate, you'll need to pull all of the cards and motherboard to put it in. It really isn't worth it. I run several systems without the outside shell cover--no real problem---the only time I see this not working properly, is with some Dell systems that don't have a cpu fan, just a fan blowing accross the heat sink on the cpu