Plextor PX-716A will not burn DVDs anymore
Posted: Wed Apr 30, 2008 9:49 pmI recently ran into some problems with my DVD burner. I'm so confused, b/c it used to work perfectly...the only advice I was told was I had to replace the IDE and do a manual test pulling it out of my computer changing the master/slave etc etc.
I do not have time to do that...any suggestions? I'm guessing the worst that could happen would be the lazer for burning DVDs is bad....that sucks. RMA it? its about a year or two old so my warranty is over.
Note: This problem happened after a lot of software was installed and used to burn DVDs so I do not know if the SCSI or ATAPI layers were messed with, everything checks out okay and my settings are the same. IMGburn, Nero, Sonicburn were the ones I tried to have consistency with.
I do not have time to do that...any suggestions? I'm guessing the worst that could happen would be the lazer for burning DVDs is bad....that sucks. RMA it? its about a year or two old so my warranty is over.
Note: This problem happened after a lot of software was installed and used to burn DVDs so I do not know if the SCSI or ATAPI layers were messed with, everything checks out okay and my settings are the same. IMGburn, Nero, Sonicburn were the ones I tried to have consistency with.