pc wont start

[clennonuk]

and this is the second

Initialization failed because the driver device could not be created


0000: 00000000 00580001 00000000 c00010d7
0010: 00000111 c000003b 00000002 00000000
0020: 00000000 00000000

[Gecko]

It looks like there is a problem with a second device on one of your IDE channels.

Muddy does have a point about running check disk, try it this way seeing that it will boot:
Right click on your C: drive select properties > tools tab > click the check now button.
Put a check next to “Automatically fix file system errors” click Start and click yes.
Now reboot your system and let the check disk run it will tell you if changes were made.

If you still have the same problem then you will need to look into what is your slave device(s) on your ide cables.

[clennonuk]

I am still getting the blue screen thats come it says
KERNEL-DATA-INPAGE-ERROR


win32k.sys.adress BF92FAA1 base at BF800000,Datestamp 3B7de698



or sometimes when i boot it comes up with Disk boot failure

[Gecko]

It's time to open up the case

Based on all the errors you have gotten, I think that you have a hardware failure on an IDE device.
Either a CD drive or a hard drive is causing the errors, it could be a cable but not likely.

I'm assuming that you have one hard drive and one cd drive
Turn of the system, disconnect the power cord, open the case and disconnect your cd drive.
Make sure that you disconnect both connectors to the cd drive, then plug the power cord in and see if it boots.

If you have more than one cd drive or hard drive then use a process of elimination, one device at a time.