Page 1 of 1

Black screen before welcome hangs on boot up

PostPosted: Wed Jan 09, 2008 5:21 pm
by Fusion
--------------------------------------------------------------------------------

Hi wonder if you can help im running XP pro just had new power supply installed what is happening is when windows loads it hangs at black screen for about 80 seconds then it goes to XP welcome screen and windows loads as normal and everything works fine and PC runs fine, i have reinstalled drivers for graphics card updated, but it still does it this was not happening before power supply went wrong

This has only happend since new power supply tried system restore and last known good config but still the same

any help appreciated

Thanks

windows XP Pro sp2
512 Ram
1.8 AMD Athlon
Nvidia 7600 Geforce GT graphics

PostPosted: Wed Jan 09, 2008 7:35 pm
by venney
so, just to be clear, since you have installed a new psu, it takes longer for your pc to boot?

PostPosted: Wed Jan 09, 2008 9:10 pm
by Fusion
yes thats correct PSU blew and had new PSU put in since then the above has been happening, but when it does load windows runs fine just hangs a black screen and takes long time to load before welcome screen comes up never did this before

Thanks

PostPosted: Thu Jan 10, 2008 1:35 am
by Gecko
Hello Fusion, amd welcome to our forum.

It sounds to me like windows is looking for some device, device driver or a network drive.

Go to Start > Control panel > Administrative tools > Event viewer > look in the system section.

You are looking for any red or yellow icons, from the last startup date only, double click on the icon.
Click inside the 'Description' section then highlight the text and copy and paste it into notepad.
At the bottom of the event window check 'words' and then copy and paste that text also
Then past it all into your reply to this thread.

If you don't show any errors in the event viewer then:
Go to Start > Control Panel > System > Advanced tab > Startup and Recovery section
Settings button > System Failure section > check the box 'Write an event to the system log'


You should also check the device manager:
Right click on My Computer > Properties > Hardware tab > Device manager.
Once a gain you are looking for any yellow question marks or red "X"s

PostPosted: Thu Jan 10, 2008 9:59 am
by Fusion
Hi and thanks for the welcome

This is what i found

Event Type: Warning
Event Source: Dhcp
Event Category: None
Event ID: 1003
Date: 10/01/2008
Time: 08:35:04
User: N/A
Computer: HOME-F9AAVQUHUR
Description:
Your computer was not able to renew its address from the network (from the DHCP Server) for the Network Card with network address 000B6B9F7EC6. The following error occurred:
The operation was canceled by the user. . Your computer will continue to try and obtain an address on its own from the network address (DHCP) server.

For more information, see Help and Support Center at http://go.microsoft.com/fwlink/events.asp.
Data:
0000: 000004c7


Event Type: Warning
Event Source: Dhcp
Event Category: None
Event ID: 1003
Date: 10/01/2008
Time: 08:35:00
User: N/A
Computer: HOME-F9AAVQUHUR
Description:
Your computer was not able to renew its address from the network (from the DHCP Server) for the Network Card with network address 000B6B9F7EC6. The following error occurred:
The operation was canceled by the user. . Your computer will continue to try and obtain an address on its own from the network address (DHCP) server.

For more information, see Help and Support Center at http://go.microsoft.com/fwlink/events.asp.
Data:
0000: 000004c7


Event Type: Error
Event Source: WMPNetworkSvc
Event Category: None
Event ID: 14344
Date: 10/01/2008
Time: 08:34:55
User: N/A
Computer: HOME-F9AAVQUHUR
Description:
A new media server was not initialized because WMCreateDeviceRegistration() encountered error '0xc00d2782'. The Windows Media DRM components on your computer might be corrupted. Verify that protected files play correctly in Windows Media Player, and then restart the WMPNetworkSvc service.

For more information, see Help and Support Center at http://go.microsoft.com/fwlink/events.asp.




Event Type: Error
Event Source: WMPNetworkSvc
Event Category: None
Event ID: 14344
Date: 10/01/2008
Time: 08:34:55
User: N/A
Computer: HOME-F9AAVQUHUR
Description:
A new media server was not initialized because WMCreateDeviceRegistration() encountered error '0xc00d2782'. The Windows Media DRM components on your computer might be corrupted. Verify that protected files play correctly in Windows Media Player, and then restart the WMPNetworkSvc service.

For more information, see Help and Support Center at http://go.microsoft.com/fwlink/events.asp.




Event Type: Warning
Event Source: Dhcp
Event Category: None
Event ID: 1003
Date: 10/01/2008
Time: 08:34:52
User: N/A
Computer: HOME-F9AAVQUHUR
Description:
Your computer was not able to renew its address from the network (from the DHCP Server) for the Network Card with network address 000B6B9F7EC6. The following error occurred:
The operation was canceled by the user. . Your computer will continue to try and obtain an address on its own from the network address (DHCP) server.

For more information, see Help and Support Center at http://go.microsoft.com/fwlink/events.asp.
Data:
0000: 000004c7


Event Type: Error
Event Source: Service Control Manager
Event Category: None
Event ID: 7000
Date: 10/01/2008
Time: 08:34:30
User: N/A
Computer: HOME-F9AAVQUHUR
Description:
The PCAMPR5 NDIS Protocol Driver service failed to start due to the following error:
The system cannot find the file specified.

For more information, see Help and Support Center at http://go.microsoft.com/fwlink/events.asp.


Event Type: Error
Event Source: Service Control Manager
Event Category: None
Event ID: 7000
Date: 10/01/2008
Time: 08:34:30
User: N/A
Computer: HOME-F9AAVQUHUR
Description:
The PCAMPR5 NDIS Protocol Driver service failed to start due to the following error:
The system cannot find the file specified.

For more information, see Help and Support Center at http://go.microsoft.com/fwlink/events.asp.




Thanks again

PostPosted: Thu Jan 10, 2008 12:44 pm
by Gecko
Fusion,

Do you have a device that syncs with your windows media player?
If so I think that's where your problem my be, you may have to uninstall this device and then reinstall it.

Also do you have any Norton products installed?

PostPosted: Tue Jan 15, 2008 2:03 am
by icecube